Oki B930dn - Tray Settings; Source; Output Destination; Input Tray Linking

Loading paper > 31
4. Insert the paper into the tray.
5. Push the tray completely into the printer.
T RAY SETTINGS
You can configure a variety of settings for your input trays and output bins. The default
settings for the source input tray and output bin are configured through the control panel’s
PAPER MENU, DEFAULT SOURCE and OUTPUT TRAY selections.
S OURCE
You can select the input tray from which the paper is to be used for the print job. Select
the desired paper source through the Source drop down from printer properties or also
enable it at the control panel or use the EWS.
O UTPUT DESTINATION
You can choose the output bin for your print job to be placed, if the finisher or stacker is
installed. Select the destination through the Destination drop down from printer
properties or enable it at the control panel or use the EWS.
I NPUT TRAY LINKING
When a chosen input tray is out of paper, auto tray changing enables the printer to switch
to another available tray that contains the same size and paper type.
NOTE
If there are no paper trays that match the automatic tray selection, an error
message prompting for replenishment of paper will be displayed on the control
panel.