Daily care > 62
D
AILY
CARE
C
LEANING
THE
PRINTER
This section describes how to clean the printer in order to maintain it in good condition and
print clean printouts all the time.
C
LEANING
THE
EXTERIOR
Clean the exterior of the printer about once a month. Wipe the parts with a wet but well-
wrung soft cloth. Then wipe with another dry soft cloth. For stubborn stains, moisten a soft
cloth with a small amount of neutral detergent, and gently wipe the stain off.
C
LEANING
THE
INTERIOR
After clearing paper jams or replacing the drum unit/toner cartridge, inspect the inside of
the printer before closing the Front cover.
> Remove any remaining pieces of paper.
> Remove any dust or stains with a clean dry cloth.
WARNING!
Be sure to switch off and unplug the machine before accessing the
interior of the machine for cleaning, maintenance, or fault
clearance. Access to a live machine’s interior can cause electric
shock.
CAUTION!
Do not spray the detergent directly on the printer. The liquid
detergent may enter the printer through a gap and cause problems.
Never use cleaning agents other than water or neutral detergent.
WARNING!
Never touch areas labelled as ‘High Voltage’. You can get an
electric shock. Never touch a labelled area found on or near the
heat roller. You can get burned. If a sheet of paper is wrapped
around the heat roller, do not try to remove it by yourself to avoid
injuries or burns. Switch off the machine immediately, and contact
service.
To Next Page
Loading...
