Loading paper > 33
H
OLE
PUNCHER
The optional finisher contains a 2-4 Hole Puncher. When installed, it must be enabled to
punch holes. When the printer detects that the punch waste box is full, a warning appears
on the control panel. Printing will continue, but the punching will stop.
To turn on hole punching on your Printer Properties:
1. Select the Paper Feed button in the Setup tab within your Printer Properties.
The Paper Feed option is displayed.
2. Select the Hole Punch type from the Hole Punch drop down.
3. Click OK.
E
MPTYING
THE
PUNCH
WASTE
BOX
To empty the punch waste basket:
1. Open door G.
For description of door locations, see “Jam area locations” on page 36.
2. Remove the Punch Waste Box and empty the contents.
3. Place the Punch Waste Box back into the finisher.
4. Close door G.
To Next Page
Loading...
