Troubleshooting > 46
3. Remove any crumpled or damaged paper and adjust the length and width guides
properly to align to the paper.
4. Push the tray completely into the printer.
5. Open cover A and remove any jammed paper. See “Inside cover A” on page 36.
6. Close cover A.
For Paper Jam in trays 3 and 4 TTM, refer to “Paper jam in high capacity feeder (tray 6)/
two tandem trays” on page 47
NOTE
Check if the paper size set on the paper tray matches the size displayed on
the Control Panel. If they match, press the Select button. If the paper size
does not match, then change it in the control panel to match.
To Next Page
Loading...
