144 - C130n User’s Guide
You are
experiencing
duplex
problems.
Media or settings are not
correct.
For autoduplexing, make sure that you
have a duplex option installed.
Make sure that you are using correct
media.
" Only Letter/A4 plain paper can be
autoduplexed.
" Do not duplex labels, postcards,
thick stock, letterheads, or plain
paper with a size other than Letter/
A4.
" Make sure that you have not mixed
media types in Tray 1.
Make sure the duplex option is installed
and declared in the Windows printer
driver (Properties/Configure tab).
In the printer driver (Layout tab),
choose “Double-sided”.
You hear
unusual
noises.
The printer is not level. Place the printer on a flat, hard, level
surface.
The tray is not installed
correctly.
Remove the tray that you are printing
from and reinsert it completely into the
printer.
There is a foreign object
stuck inside the printer.
Turn off the printer and remove the
object. If you cannot remove it, contact
Technical Support.
Media is
wrinkled.
The media is moist from
humidity or having water
spilled on it.
Remove the moist media and replace it
with new, dry media.
The media feed roller or
fuser unit is defective.
Check them for damage. If necessary,
contact Technical Support with the
error information.
Unsupported media (wrong
size, thickness, type, etc.) is
being used.
Use good quality recommended media.
See
“Print Media” on page 53.
Symptom Cause Solution
To Next Page
Loading...
Need help?
General
