- 60 -
2. Setting Up
10
Press [Back] until the home screen is displayed.
Wireless LAN (AP mode) directly connects wireless devices (computers, tablets,
smartphones, etc.) to the machine without using a wireless LAN access point.
• If there is metal, aluminum sash, or a reinforced concrete wall between the machine and wireless devices,
connections may be harder to be established.
• Up to four devices can be connected to the machine via the wireless LAN (AP mode). The fifth device will be rejected.
• Automatic connection (push-button)
If your wireless devices support WPS-PBC (push button), you can connect them to the
machine with the WPS button.
• Manual Setup
If your wireless devices do not support WPS-PBC (push button), you can enter [SSID] and
[Password] of the machine in your wireless devices to connect to the wireless LAN (AP
mode).
Automatic connection (push-button)
If your wireless devices support WPS-PBC (push button), you can connect them to the
machine with the WPS button.
1
Confirm the position of the WPS button on your wireless device by the manual
attached to the device.
2
Turn on the machine.
If the "Do you want to Set-up wireless?" message appears, select the [Do not show next time.] check box, and
then press [No].
3
Press [Device Settings] on the touch panel.
4
Press [Admin Setup].
5
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "999999"
respectively.
Connecting to the Machine Directly (AP mode)
To Next Page
Loading...
Need help?
General
