Oki MC350

Access control > 53
2. Using the Down arrow key, highlight Yes and then press Enter to confirm.
The display reverts to the Enter PIN screen.
O PERATION TIME - OUT
> When the MFP control panel is left inactive for a prescribed length of time (Operation
Time-out), the display automatically reverts to the Idle screen if Access Control is
disabled.
> If an error state occurs, Operation Time-out is disabled.
> After Operation Time-out, the display automatically reverts to the Enter PIN screen
if Access Control is enabled.
> The length of the Operation Time-out depends on the setting in Menu Mode >
Admin Setup > System Setup > Return to Standby Time.
NOTE
When the MFP control panel is left inactive for a prescribed length of time, the
display automatically reverts to the Enter PIN screen if Access Control is
enabled.
Downloaded From ManualsPrinter.com Manuals