Copying > 58
4. Press the Left arrow key to return to the start menu.
b. The setting displayed, mm or inch, depends on the setting in Admin Setup -
System Setup - Unit of Measure in Menu Mode. If Edge Erase is set to other than
“0 mm” or “0.00 in,” Reduce/Enlarge always defaults to “100%,” N-up to “1in1,”
and Margin Shift-Right/Bottom to “0 mm (0.00 in)”.
c. Any parts of the image that do not fit on the paper as a result of this setting, are
not printed. The setting displayed, mm or inch, depends on the setting in Admin
Setup - System Setup - Unit of Measure in Menu Mode. If Margin Shift-Right is set
to other than “0 mm” or “0.00 in,” Edge Erase always defaults to “0mm (0.00in)”
and Reduce/Enlarge can be set only to less than 100%.
d. Any parts of the image that do not fit on the paper as a result are printed. The
setting displayed, mm or inch, depends on the setting in Admin Setup - System
Setup - Unit of Measure in Menu Mode. If Margin Shift-Bottom is set to other than
“0 mm” or “0.00 in,” Edge Erase always defaults to “0mm (0.00in)” and Reduce/
Enlarge can be set only to less than 100%.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
