Scanning > 74
7. Press the to select the destination you want and then press OK.
8. Press
or .
9. Start the ActKey on your computer.
10. Click a scan button.
For Mac OS X
1. Press the SCAN key on the operator panel.
2. Place your document with text face up in the ADF or face down on the document glass.
3. Press the to select Remote Scan and then press OK.
4. Check that the TWAIN is selected, and press OK.
5. Check that Select a connecting PC is selected and then press OK.
6. Check that From Network is selected and then press OK.
7. Press the to select the destination you want and then press OK.
8. Press
or .
9. If your device’s PC Scan Mode is set to Secure Scan Mode, you must use the Network
Scanner Setup Tool to make the following settings:
>The address of your Mac must be registered with your device.
>The port number used for scanning must be registered. This port number can be
changed in your device’s “Network Scan Destination” settings.
The Network Scanner Setup Tool is installed in the following location:
/Applications/OKIDATA/Scanner/
Start the Network Scanner Setup Tool, select your MFP device and change the
settings.
10. Start Image Capture on your computer.
11. Select the device.
12. Click a scan button.
Scanning starts.
13. Select Quit Image Capture from Image Capture.
For WSD Scan
1. Press the SCAN key on the Operation Panel.
2. Place the original on the automatic document feeder or on the scanner glass.
3. Press the to select Remote Scan and then press OK.
4. Press the to select WSD Scan and then press OK.
5. Start any scan program on the PC.
6. Click a scan button. The document scan starts.
MONO
COLO
MONO
COLO
To Next Page
Loading...
Need help?
General
