Oki Microline 490 User Manual

Using Your Printer 25
Printer Reset
Clearing some error conditions requires that you reset
(reinitialize) the printer. To do this:
1 Press and release
SEL (1) to take the printer off-line.
The SEL light goes out.
2 Press and hold
SHIFT (2), then press RESET/CHARACTER
PITCH.
Important!
Pressing
SHIFT + RESET reinitializes the printer, but does not
affect any menu settings and does not reset the printer to the
factory defaults. For information on resetting the printer to
the factory defaults, see “Resetting the Menu to the Factory
Defaults” later in this chapter.
Emulations
• Epson
®
LQ — factory setting
•IBM
®
Proprinter
•IBM
®
AGM
Changing Emulations
1 Make sure paper is loaded.
2 Press and hold
SHIFT (2), then press SEL (1).
3 Press
LF (3).
The following line prints:
Printer Control Emulation Mode EPSON LQ
4 Press TEAR (4) repeatedly until the emulation you wish to
select prints in the right-hand column.
5 Press and hold
SHIFT (2), then press SEL (1) to save your
setting and exit the Menu Mode.

Oki Microline 490 Specifications

General

Brand	Oki
Model	Microline 490
Category	Printer
Language	English