15
Release The Paper Chains – Cabinet Model
NOTE: Steps 1– 3 in this section are for the passive stacker. If you
have the power paper stacker installed, skip this procedure
and go to “Remove The Shipping Restraints From The
Power Paper Stacker (If Equipped)” on page 17.
Figure 8. Releasing the Paper Stacking Chains
1. Open the cabinet rear door.
2. Cut the tie wraps and release the paper stacking chains from
the bags at the top rear of the printer frame. Remove the tie
wraps and bags.
3. Make sure each chain hangs freely with no kinks or knots.
Tie Wrap (2)
Paper Chain (8)
Bag (2)
Release The Paper Chains – Cabinet Model
To Next Page
Loading...
Need help?
General