12 Microline 320/321 Turbo/n
|
Operation Tip: Turning the Platen Knob
!
If you turn the platen knob when the printer is turned
on, you will cause the Top of Form to mis-align. Always
turn the printer off before turning the platen knob!
Operation Tip: Using the Parallel Port
!
If you want to use the parallel port, you MUST remove
the Network Card from the printer.
See the OkiLAN 6120e User’s Guide for details.
Operation Tip: Control Access to the
Printer
You can control access to the printer by changing the setting
for the Operator Panel Function (in the Menu).
When the Operator Panel Function is set to Full Operation
(the factory default), all keys on the front panel operate.
When the Operator Panel Function is set to Limited
Operation, the PRINT QUALITY and CHARACTER PITCH
keys don’t work. This prevents these settings from being
changed from the control panel when several people are
using the printer.
For more information, refer to “Using Your Printer, Menu
Mode, Menu Settings Table, Setup, Operator Panel
Function.”
To Next Page
Loading...
