34 Microline 320/321 Turbo/n
|
Font Sample Test
!
Wide Carriage Model
Microline 321 Turbo/n
If you are using 8.5 inch paper to run the test, make sure
the paper width selection in the printer menu is set to
8.5 inches. Otherwise, printing on the platen may
damage the printer. Refer to “Using Your Printer, Menu
Mode, Explanations of Menu Items.”
!
The Font Sample Test automatically stops after all the
available fonts print.
The Font Sample Test prints a sample of the fonts standard to
the printer.
The top of the printout has the Printer Model, Emulation,
Country Code, Interface, and Firmware Revision Level for
your printer.
To run the test:
• Turn the printer off, then press and hold the LF key
while turning the printer back on.
LF.eps
LF
GROUP
Micro Feed
Down
To exit the test:
• Press SEL.
SEL.eps
SEL
SEL
MENU
To Next Page
Loading...
Need help?
General
