46 Microline 320/321 Turbo/n
|
Setting Top of Form, Forms Tear-Off OFF
(Step B)
!
If you turn the platen knob when the printer is turned
on, you will cause the Top of Form to mis-align. Always
turn the printer off before turning the platen knob!
!
Always determine the status of the Forms Tear-Off menu
setting BEFORE setting the Top of Form. Refer to
“Using Your Printer, Top of Form, Forms Tear-Off
Status (ON or OFF).”
1 Turn the printer ON.
2 Press SEL/MENU (6) to take the printer off line. The
SEL light goes out.
3 Press and hold SHIFT (1).
Then, press LF / Micro Feed Down (2) or FF/LOAD /
Micro Feed Up (3), depending on which direction you
want to move the paper to align the tear-off position.
To Next Page
Loading...
Need help?
General
