QUIETPARKTEAR
FF/LOAD
LF
SEL
SEL
POWER ALARM
MENU
GROUPEXIT
ITEM SET
PRINT
MENU
SHIFT
TOF
Micro Feed
Up
Micro Feed
Down
PRINT QUALITY
CHARACTER PITCH
HSD
NLQ
UTL
SSD
10 12 15
17
20 PROP
➊
➊
5. Adjust the paper feed guides (➊) for the width of the
paper and place a sheet of paper in the separator. The
paper will feed into the printer.
Note: The standard setting for the Top of Form (where
the printing begins) is 2.54cm down from the top of
the page. To change the setting, see the next column.
Setting the Top of Form (TOF)
When setting the Top of Form, use the red line (➊) on the
paper shield as a reference:
1. Make sure the printer is deselected (SEL light off).
2. Press and hold SHIFT (➊), then:
☛ Press LF (➋) to move Top of Form higher on page
☛ Press FF/LOAD (➌) to move Top of Form lower on
page
To Next Page
Loading...
Need help?
General
