Oki ML5100FB - Page 29

Operating instructions > 29
Auto CR
*IBM PPR only
Select whether to perform auto
CR operation upon receiving a
carriage return command.
Yes
No
SI Select Pitch (10CPI)
*IBM PPR/AGM only
Set how to handle an SI
command received in 10 CPI
mode.
15 CPI
17.1 CPI
SI Select Pitch (12CPI)
*IBM PPR/AGM only
Set how to handle an SI
command received in 12 CPI
mode.
12 CPI
20 CPI
Reset Inhibit Set whether to enable or
disable an initial command.
No
Yes
Select Language Set
*EPSON only
Set whether to enable or
disable a combination of the
code page setting and the
language setting by menu.
Combined
Code Page Only
Impact Mode Select print mode on power on.
(This item is referred to on
initialisation only by I-PRIME or
power on but not by an
initialisation command.)
Normal
Quiet
Hi Copy
Print Direction Command Select the validity of a one-way
print setup command.
Valid
Invalid
Power Saving Set whether to enable or
disable power save mode.
Enable
Disable
Power Save Time Set idle time to enter power
save mode.
5 min, 10 min, 15 min, 30 min,
60 min
PE Detection Select whether to detect paper
end or not.
OFF
ON
Table Print Set whether to divide a path or
not to print on occasions when
printing by the same headpin
continues for 3 in or more in the
same print block.
Standard
Special
Carriage Position when
cut sheet Gap 1
Selects the carriage position for
cut sheet paper fed (paper
thickness level 1).
Left
Middle
Right
Carriage Position when
cut sheet Gap > 1
Selects the carriage position for
cut sheet paper fed (paper
thickness level 2 or more).
Left
Middle
Right
Paper width mode Selects continuous form paper
width used. Select Mode1 when
using paper
≥8 inches wide,
Mode2 when using paper >5
but <8 inches wide, and Mode3
when using paper less than <5
inches wide.
Mode1
Mode2
Mode3
ITEM FUNCTION SETTING