Oki ML5100FB - Page 30

Operating instructions > 30
Continuous paper top LF
adjust Gap1
Selects top LF correction
amount for continuous form
paper, when paper thickness
level is 1 (Gap 1). The positive
range adds correction amounts
to the LF, and the negative
range reduces the correction
amounts to the LF. The amount
of LF is in 1/360 inch
increments.
-3 - -1
0
+3 - +1
Continuous paper top LF
adjust Gap2
Selects top LF correction
amount for continuous form
paper, when paper thickness
level is 2 (Gap 2). The positive
range adds correction amounts
to the LF, and the negative
range reduces the correction
amounts to the LF. The amount
of LF is in 1/360 inch
increments.
-3 - -1
0
+3 - +1
Continuous paper top LF
adjust Gap3
Selects top LF correction
amount for continuous form
paper, when paper thickness
level is 3 (Gap 3). The positive
range adds correction amounts
to the LF, and the negative
range reduces the correction
amounts to the LF. The amount
of LF is in 1/360 inch
increments.
-3 - -1
0
+3 - +1
Continuous paper top LF
adjust Gap4
Selects top LF correction
amount for continuous form
paper, when paper thickness
level is 4 (Gap 4). The positive
range adds correction amounts
to the LF, and the negative
range reduces the correction
amounts to the LF. The amount
of LF is in 1/360 inch
increments.
-3 - -1
0
+3 - +1
Line Spacing Select line feed pitch. 6 LPI
8 LPI
Form Tear-Off Select manual or auto as the
method to advance a
continuous form to the form
tear-off position.
Off
500 ms
1 sec
2 sec
Skip Over Perforation Select whether to skip over
perforation or not. (When a skip
over perforation setup
command is received, the
received command is given
priority.)
Yes
No
Page Length
(Continuous)
Select the length of a
continuous form.
3.5 in, 4 in, 5.5 in, 6 in, 7 in,
8 in, 8.5 in, 11 in, 11 2/3 in,
12 in, 14 in, 17 in, 5 in, 3 in,
3.25 in
ITEM FUNCTION SETTING