Operating instructions > 31
TOF (Continuous) Select the reference position for
the TOF position when auto
loading continuous form paper
from the rear of the printer. (Up
to the mid-section of characters
in the first line.)
2.12 mm (1/12 in)
4.23 mm (1/6 in)
6.35 mm (1/4 in)
8.47 mm (1/3 in)
10.58 mm (5/12 in)
12.7 mm (1/2 in)
14.82 mm (7/12 in)
16.93 mm (2/3 in)
19.05 mm (3/4 in)
21.17 mm (5/6 in)
23.28 mm (11/12 in)
25.4 mm (1 in)
27.52 mm (13/12 in)
1Chr. Set Pos.
Initial Position This is the position of the paper
when the paper is already
loaded at power on. (For
continuous form mode only.)
Print
Tea r OFF
Auto Eject Position Select a printable area at the
bottom of cut sheets of paper in
cut-paper mode (the character
centre position).
6.35 mm (1/4 in)
14.8 mm
Page Length (Cut Sheet) Select the page length of cut-
paper.
3.5 in, 4 in, 5.5 in, 6 in, 7 in, 8
in, 8.5 in, 11 in, 11 2/3 in, 12
in, 14 in, 16.57 in, 5 in, 3 in,
3.25 in
TOF (Cut Sheet) Select the reference position for
the TOF position when feeding
cut-paper in manual mode. (Up
to the mid-section of characters
in the first line.)
2.12 mm (1/12 in)
4.23 mm (1/6 in)
6.35 mm (1/4 in)
8.47 mm (1/3 in)
10.58 mm (5/12 in)
12.7 mm (1/2 in)
14.82 mm (7/12 in)
16.93 mm (2/3 in)
19.05 mm (3/4 in)
21.17 mm (5/6 in)
23.28 mm (11/12 in)
25.4 mm (1 in)
27.52 mm (13/12 in)
1Chr. Set Pos.
Wait Time Select the waiting time between
setting paper on the tray and
feeding it while the printer is
waiting for paper to be fed in
cut-paper manual feed mode.
500 ms
1 sec
2 sec
FF Function
*EPSON only
Set feeding operation upon
receiving an FF code after cut-
paper is fed.
Eject
Form Feed
I-Prime Select whether to print or clear
buffer contents upon
initialisation by receiving I-
PRIME.
Invalid
Buffer Clear
Buffer Print
Auto Feed XT
*EPSON only
Set the validity of an Auto Feed
XT signal.
Valid
Invalid
I/F Bi-Direction Set whether to return a device
ID or not in accordance with
IEEE1284.
Enable
Disable
ITEM FUNCTION SETTING
To Next Page
Loading...
