Operating instructions > 32
Parity
(Displayed when
connected to a Serial
Interface)
None: Absence of parity bit
Odd: Odd parity
Even: Even parity
Ignore: Do not convert the
character to ox40 in case of
parity error.
None
Odd
Even
Ignore
Serial Bits
(Displayed when
connected to a Serial
Interface)
Select the data bit length. 7 Bits
8 Bits
Protocol
(Displayed when
connected to a Serial
Interface)
Select an I/F Busy control
method.
Ready/Busy: Busy control by a
DTR signal
X-ON/X-OFF: Busy control by a
DC3/DC code
DTR X-On/X-OFF: Busy control
DTR Signal and DC3/DCT
control.
Ready/Busy
X-On/X-OFF
DTR X-ON/X-OFF
Diagnostic Test
(Displayed when
connected to a Serial
Interface)
Select to perform input/output
diagnosis of
RS-232C interface signals.
No
YES
Baud Rate
(Displayed when
connected to a Serial
Interface)
Select to set the Baud rate. 300bps
600bps
1200bps
2400bps
4800bps
9600bps
19,200 bps
DTR Signal
(Displayed when
connected to a Serial
Interface)
Set a method to switch a DTR
signal of a serial interface.
Ready on Power UP
Ready on Select
Busy Time
(Displayed when
connected to a Serial
Interface)
Set the minimum time between
BUSY to READY.
0.2 sec
1 sec
TOF Adjustment
(Cut Sheet)
Select an adjustment value for
the reference position in regard
to the TOF position of cut-
paper/passbooks.
The position moves to the rear
of the form by [+] and to the
top of the form by [-] in 1/60 in
increments.
-7 – -1
0
+7 – +1
Rear Load Adjustment Select an adjustment value for
the reference position in regard
to the TOF position of a
continuous form.
The position moves to the rear
of the form by [+] and to the
top of the form by [-] in 1/60 in
increments.
-7 – -1
0
+7 – +1
Cut Position Adjust Select an adjustment value for
the position to cut the end of a
continuous form. (In 1/90 in
increments)
-7 – -1
0
+7 – +1
ITEM FUNCTION SETTING
To Next Page
Loading...
