Oki PACEMARK 4410 - Page 103

102
Apply a small amount of Albania grease
on the bearing sliding surface.
(All periphery) (GEP- B )(both right and left)
Apply a little amount of Albania grease
on lack gear teeth surface.
(GEP- B )
Apply a little amount of Albania grease
on the diagonally shaded section.
(GEP- B )(4 points)
Apply a small amount of Albania grease
on the teeth surface of the rack.
(GEP- B )(both right and left)
Apply a small amount of Albania grease
on the stud sliding surface.
(All periphery)(GEP- B )(both right and left)
Apply a small amount of Albania grease
on the diagonally shaded section.
(GEP- B )
Apply a small amount of Albania grease
on the feed shaft sliding surface.
(GEP- B )(top and bottom)(both right and left)
Bail lift lever oblique view
Tractor change lever Assy oblique view