87
4. ADJUSTMENTS
(1) Be sure to carry out this adjustment with the printer mechanism mounted on the lower cover.
(2) Be sure to carry out this adjustment operation on a level and highly rigid work table (flatness:
less than 0.039 inch or 1 mm) so as to minimize adjustment error.
[Service Tool]
• No. 2-200 Philips screwdriver
• No. 2-200 screwdriver
• Feeler gauge
• 500 g rod tension gauge
• Calipers
Adjustment should be conducted after removing the Rear Cover (B) and setting the Dip Switch 1
on the board to “ON”(maintenance mode). (See Note 1 and 2)
Note 1: After the adjustment and lubrication have completed, set the all the dip switches to
“OFF”(normal operation mode), and fix the Rear Cover (B) with the mounting screws.
Note 2: The local test printing except for the menu printing should be implemented with all the dip
switches set to “OFF”(normal operation mode).
To Next Page
Loading...
