58
3.3.5 PG Cooling Fan
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front
/ Frame Assy Rear. (See 3.3.1)
(2) Unplug the connectors 2 to Junction Board (PRA Printed Board)(CN13)1.
(3) Unscrew 2 screws 3 and remove PG Cooling Fan 4.
(4) For installation, reverse the removal procedure.
(Note on Installation)
1.Mount the fan to produce wind in the direction as indicated on PG Fan Bracket 5.
2.The fan should be installed, matching the direction of air flow to the direction of arrow shown
in the figure.
1
2
3
4
CN13
Air Flow
To Next Page
Loading...
