73
3.3.20Ribbon Protector
(1) Remove Printing Head. (See 3.3.18)
(2) Open Access Cover 1.
(3) Unscrew the screw 2 and remove the cord clamp 3.
(4) Unscrew the screw 4 and remove Paper Width Sensor 5.
(5) Unplug the connector 6.
(6) Remove 2 Ribbon Guide Posts 7 and 2 washers 8.
(7) Remove Ribbon Protector 9.
(8) For installation, reverse the removal procedure.
(Note on Installation)
1.In assembling the ribbon protector, make an adjustment according to the Section 1 (2)
Protector Gap of 4. ADJUSTMENTS.
1
7
8
9
5
6
4
3
2
To Next Page
Loading...
