71
3.3.18Printhead
(1) Lean Frame Assy Rear backward and open Access Cover.
(2) Move the printhead to the recess on the right seen from the front.
(3) Pull out Ribbon Guide 1 upward.
(4) Unscrew 2 screws 2 and remove Printhead 3 from the connector.
(5) For installation, reverse the removal procedure.
(Note on Installation)
1.The head should be installed according to Section 9, Procedure for Installing Printhead in
Section 4 - ADJUSTMENTS.
1
2
3
To Next Page
Loading...
