74
3.3.21Space Motor Fan
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front
/ Frame Assy Rear / Plate Front (stuck). (See 3.3.1)
(2) Remove Printer Unit. (See 3.3.2)
(3) Unscrew 2 screws 1 and unplug the connector 2 from Junction Board (PRA Printed Board)
(CN12) 4, then remove Space Motor Fan 3.
(4) For installation, reverse the removal procedure.
(Note on Installation)
1.The fan should be installed, matching the direction of air flow to the direction of arrow shown
in the figure.
1
3
2
4
CN12
Air Flow
To Next Page
Loading...
