67
3.3.14Head Cooling Fan 2
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front
/ Frame Assy Rear / Plate Front (stuck). (See 3.3.1)
(2) Unscrew the screw 1 and remove Cable Holder Cover 2.
(3) Unplug the connector 3 from I/F Board (PHA Printed Board)(CN6) 6.
(4) Release the cords from the cord clamps on the cord route.
(5) Unscrew 2 screws 4 and remove Head Cleaning Fan 2 5.
(6) For installation, reverse the removal procedure.
(Note on Installation)
1.The fan should be installed, matching the direction of air flow to the direction of arrow shown
in the figure.
1
2
4
4
5
3
6
Air Flow
To Next Page
Loading...
