76
3.3.23Cover Open Switch Assy / Ribbon Rotation Sensor
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front
/ Frame Assy Rear / Plate Front (stuck). (See 3.3.1)
(2) Remove Head Cooling Fan 1. (See 3.3.13)
(3) Unscrew the screw 1 and 2 screws 2, and remove Ribbon Bracket 3.
(4) Unplug the connector 4 from Junction Board (PRA Printed Board) (CN4) 8, then remove
Cover Open Switch Assy / Ribbon Rotation Sensor 5.
(5) Unscrew 2 screws 6 and remove Cover Open Switch Assy 7.
(6) For installation, reverse the removal procedure.
(Note on Installation)
1.In assembling the microswitch, position it until backlash is removed.
1
2
2
3
4
5
6
7
CN4
Note1
In installing the microswitch,raise it in the direction of
arrow until backlash is removed.
MicroSW assembly detail
To Next Page
Loading...
