Oki PACEMARK 4410 - AG Plate Gap; Auto Gap Correction

89
Item No.
2
3
Items
AG Plate Gap
Auto Gap Correction
Standard Value
C=0.14
± 0.02mm
Illustration
3 Turn on the printer while pressing
Switches
B and C .
4 The auto gap correction has completed
if “Av” is printed.
Adjustment Method
1 Insert the thickness gauge between
the AG frame and the AG plate to veri-
fy the gap value C is between 0.12 and
0.16 mm.
2 If adjustment is required, screw down
the mounting screws and adjust the ec-
centric collar to make the protector gap
value C between 0.12 and 0.16 mm,
then fix the AG plate.
Notes:
After this Adjustment, the Auto Gap
Correction should be conducted (See
item 3)
1 Set the continuous form (1P, 15 in.
wide and 55 Kg) at the printing valid po-
sition and also the ribbon cassette.
2 Turn off the printer, then power on
again while pressing Switches
B and
C to conduct the auto correction. If the
auto gap operation has been repeated
3 times and “Av= “ printed, it is the
end of the auto gap correction.
3 The auto correction value from 09 H
to 18 H is desirable. If any value other
than this is indicated, the AG plate gap
should be adjusted again. (See Item 2)
Notes:
a) In the following cases, this adjust-
ment should be implemented.
i)After the gap adjustment between the
AG frame and the AG plate;
ii)After replacing the control board. (not
required after CG/PROGROM, EE-
PROM replacement)
b) When the correction value “Av= “ is
not between 09 and 18, “Warning” will
be indicated on the LCD panel. Press
Switch 1 to reset this warning.
c) The correction value “Av= “ from
09 to 18 is desirable. If any value oth-
er than this is indicated, the gap bet-
ween the AG frame and the AG plate
should be adjusted again to the prop-
er range as described in Item 2.
Then, conduct this correction.
C
AG Frame
AG Plate
Eccentric Collar
Carriage Frame
Mounting Screws
PARKTEAR
PATH
ONLINE
RESET
GROUP
POWER
ALARM
ITEM OPTION
MENU
STORE
TOF
SHIFT
ON-LINE EPS
FRONT FEED
CONFIG
LF
MicroFeed
Down
FF/LOAD
MicroFeed
Up
1
2 3 4
5
6
7
8
9 0 A B C
1
2
3
1st =0EH
2nd =0DH
3rd =0EH
AVE=0EH