Oki Pro1040 - Replacing the Fuser and Exit Unit

- 70 -
Replacing Consumables
Replacing the Fuser and Exit Unit
Replacing the Fuser and Exit Unit
CAUTIO
N
There is a risk of burns.
Work carefully because the fuser and exit unit is
very hot. Be sure to hold the fuser and exit unit
handle when you lift it. When it is hot, wait until it
cools down before starting the work.
1
If roll paper has been fed through the
printer, press the <UNLOAD> button to
cut the roll paper.
The cut paper will be fed to the supply
side and the feeding side.
2
While pulling the fuser and exit unit
locking lever towards you, pull out the
fuser and exit unit.
Note
z
Be careful, the fuser and exit unit is very hot
immediately after printing.