Oki Pro1040 - Cleaning the Unwinder

- 74 -
Printer Maintenance
Cleaning the Unwinder
This section describes how to clean the various
parts of the unwinder.
Cleaning the Surfaces of the
Unwinder
Note
z
Do not use Benzene or thinner as it may damage plastic
parts and coating.
z
Only use water or neutral washing agent.
z
It is not necessary to oil the unwinder. Do not oil it.
1
Press and hold the <POWER> button
for approximately 1 second to switch off
the power supply.
Wait a moment, and the LED lamp on
the <POWER> button will turn OFF.
2
Take water or neutral washing agent on
one piece of cotton cloth, and wipe with
thoroughly squeezed cloth.
Furthermore, wipe off with another dry
cotton cloth.
Clean the Inside of the Unwinder
1
Press and hold the <POWER> button
for approximately 1 second to switch off
the power supply.
Wait a moment, and the LED lamp on
the <POWER> button will turn OFF.
2
Open the flange locking lever.