Oki Pro1040 - Printer Maintenance; Things to Prepare; Cleaning Schedule

- 73 -
Printer Maintenance
⿟
Printer Maintenance
This section describes how to clean the various parts of the printer.
Things to Prepare
Prepare the following things for cleaning the various parts of the printer.
z
Wiper (or equivalent product)
z
Cleaning fluid (isopropyl alcohol)
z
Water or neutral cleanser
z
Cotton swabs
Cleaning Schedule
Check the condition of the equipment at the start and end of operations, and clean it as needed.
Cleaning guidelines are noted below.
Cleaning schedule
Everyday When dirt is
noticeable
Unwinder Surface
－ ○
Flange
○ ○
Side-Guide-8Inch
○ ○
Tension Bar
○ ○
Guide-Side-Roller-F
○ ○
Unwinder Paper Guide
○ ○
Sheet Guide
○ ○
Roll Paper Guide
○ ○
F0 Roller Unit
○ ○
Sensor Cover(Upper)
○ ○
Sensor Cover(Lower)
○ ○
F1 Roller Unit
－ ○
Cutter Unit
○ ○
Printer Surface
－ ○
Paper Guide
○ ○
Feed Unit
○ ○
Sensor Cover(Lower)
○ ○
Sensor Cover(Upper)
○ ○
Exit Unit
－ ○
LED Heads
－ ○
Fuser Unit
－ ○*
* :
Note
z
Clean the feed path (including rollers) and fuser unit when changing the width of the roll paper.
Streaks may appear when printing, particularly after changing the paper width from narrow to wide, because of the traces (paper
dust etc.) left along the width of the paper.
When you change the width of the roll paper, check the conditions of the fuser unit and feed path and clean them, and then
restart printing.
z
Wear gloves to clean if you are using cleaning fluid.
z
Refer to the “Setup Guide” regarding the names and functions of parts.