DOLCECLIMA BREZZA
EN - 7
ENGLISH
The maximum number of pieces of equipment permitted to be stored together will be deter-
mined by local regulations.
22. INFORMATION ON SERVICING
a) Checks to the area
Prior to beginning work on systems containing ammable refrigerants, safety checks
are necessary to ensure that the risk of ignition is minimised.
For repair to the refrigerating system, the following precautions shall be complied with
prior to conducting work on the system.
b) Work procedure
Work shall be undertaken under a controlled procedure so as to minimise the risk of a
ammable gas or vapour being present while the work is being performed.
c) General work area
All maintenance staff and others working in the local area shall be instructed on the
nature of work being carried out.
Work in conned spaces shall be avoided.
The area around the workspace shall be sectioned off.
Ensure that the conditions within the area have been made safe by control of ammable
material.
d) Checking for presence of refrigerant
The area shall be checked with an appropriate refrigerant detector prior to and during
work, to ensure the technician is aware of potentially ammable atmospheres.
Ensure that the leak detection equipment being used is suitable for use with ammable
refrigerants, i.e. non-sparking, adequately sealed or intrinsically safe.
e) Presence of re extinguisher
If any hot work is to be conducted on the refrigeration equipment or any associated
parts, appropriate re extinguishing equipment shall be available at hand.
Have a dry powder or CO2 re extinguisher adjacent to the charging area.
f) No ignition sources
No person carrying out work in relation to a refrigeration system which involves expos-
ing any pipe work that contains or has contained ammable refrigerant shall use any
sources of ignition in such a manner that it may lead to the risk of re or explosion.
All possible ignition sources, including cigarette smoking, should be kept sufciently far
away from the site of installation, repairing, removing and disposal, during which am-
mable refrigerant can possibly be released to the surrounding space.
Prior to work taking place, the area around the equipment is to be surveyed to make
sure that there are no ammable hazards or ignition risks. No Smoking signs shall be
displayed.
g) Ventilated area
Ensure that the area is in the open or that it is adequately ventilated before breaking into
the system or conducting any hot work.
A degree of ventilation shall continue during the period that the work is carried out.
The ventilation should safely disperse any released refrigerant and preferably expel it
externally into the atmosphere.
h) Checks to the refrigeration equipment
Where electrical components are being changed, they shall be t for the purpose and
to the correct specication. At all times the manufacturer’s maintenance and service
guidelines shall be followed. If in doubt consult the manufacturer’s technical department
for assistance.
The following checks shall be applied to installations using ammable refrigerants:
The charge size is in accordance with the room size within which the refrigerant contain-
ing parts are installed; The ventilation machinery and outlets are operating adequately
and are not obstructed; If an indirect refrigerating circuit is being used, the secondary
To Next Page
Loading...
