5
ENGLISH
Full Reset - All Data
A Full Reset - All Data operation erases the cash regis-
ter's working memory, all totals and counters (all report
data) and cancels all cash register programming data.
Be extremely careful when using this reset operation.
Use this method as last resort only.
1. Turn the Control Lock key to the OFF position.
2. Press and hold down
while pressing
.
3. Reprogram the cash register.
Electronic Journal
The cash register is equipped with a dynamic Electronic
Journal (EJ) memory that by default contains up to 9,000
lines of sales data. During transactions, the sales data are
continuously recorded in this memory so that you are con-
stantly kept up-to-date with the latest 9,000 lines of effective
sales information.
You can, however, program the cash register for standard
electronic journal opertion. In this case you program the
memory to hold a maximum of 9,000 sales data lines before
being promped to clear the memory. The electronic journal
stores all the sales receipts recorded in the REG and MGR
modes, thus allowing you to print this record at any time or
when memory reaches the nearly full or full condition.
To program the cash register for standard electronic journal
operation:
1. Control lock key position: PRG.
2. Press
.
NOTE: You can also personalize other electronic journal
features, such as increasing its line capacity to up to 13,000
lines or to also store invoice receipts, by programming
System Options 40, 41, 42, 44, 45, 53 and 95. See "System
Options" for details.
To know how many lines are remaining in the electronic
journal, press
in the REG mode and
outside of a sales transaction.
When the electronic journal reaches a nearly full condition,
there are less than 700 lines remaining in journal memory. A
message is displayed indicating the number of lines remain-
ing and a warning beep will sound at the beginning and end
of each transaction performed; press
or and
continue your transaction. Then either print the contents of
the electronic journal, as explained below, or continue with
further transactions.
When the journal reaches a full condition, less than 300
lines are remaining in memory. A message is displayed
indicating that the journal memory is full along with a warning
beep at the beginning of a transaction; press
or
and continue your transaction.
Then either print the contents of the electronic journal, as
explained below, or continue with further transactions; re-
member, however, that the transaction data will NOT be
stored in memory and the consecutive receipt counter will
not increase. If you want to terminate the sales transaction,
press
.
Printing and Clearing the Contents of the
Electronic Journal
Make sure that plenty of paper is loaded in the printer.
1. Control lock key position: Z.
2. Press
.
To interrupt report printing, press
. To resume printing,
press
again. To stop report printing, press .
When the contents of the electronic journal are printed, a
message is displayed along with a beep to indicate that the
EJ memory capacity has been restored to its maximum
programmed line capacity.
NOTE: You can also print the contents of the electronic
journal with the control switch in the X position; doing so,
however, will not clear the electronic memory.
Clearing Electronic Journal Memory Without
Printing the Contents
The electronic journal memory contents are cleared and not
printed:
1. Control lock key position: Z.
2. Press
.
To Next Page
Loading...
Need help?
General
