Olympus BH2 Series - Base Unit Assembly

E. ADJUSTMENT (B2-BDS -3)
No. E-2
2. Checking the minimum voltage value
2-l Verify that the voltage is DC2.5V when the light intensity control lever
is set to the "MIN" position in the same state as "l. j\djusting the
maximum voltage value".
Light
intensity
Min.
voltage
controller
Min. DC2.5V or lower
3. Checking the LED indication voltage
3-l Set the light intensity control lever so that all the LEDs up to "9" are
lit and the LED of "9.5" is not lit in the LED indication shown below.
* LED of "9.5" = LED located between "9" and "10"
Verify that the output voltage is DC 9.0 !8:27v then.
3 6
7
8 9
10 11
12
L_ ____ L_E __ D_s __ u_p __ t_o ___ "_9_" __ a_r_e __ l_l_·t __ . __ ~l Ll _______ o_F_F ________ ~
Voltage
indica-
Standard
value
tion LED
Lit up to "9"
DC
9.0~~:~
7
(V)
3-2 Verify that only the LED of "3" is lit when the light intensity
control lever is set to the "MIN" position.
3 6
7 8
9
10
11 12
L Only the LED of "3" i'
OFF
lit.