Olympus bx40 - Assembly Procedure

U-BI30
Alo
F.
ASSEMBLY
ASSEMBLING THE BI UNIT
PROCEDURE
1-1 Assemble the L-SLEEVE ASS'Y,
(1) Attach the DIOPTER RTNG (1)to the
HELICOID ASS'Y (2)as shown left
and tighten temporarily with
three screws.
Screw ACU3x3SA 3 pcs. (*1)
* when replacing the grease of
the HELICOID ASS'y, avoid re-
moving the helicoid ring as far
as possible. If the helicoid
ring is removed, have a
spare HELICOID ASS'y available.
Grease OT2008
1-2 Assemble the R-SLEEVE ASS'Y.
(1) Screw the ADJ. RING (2)a11 the way
onto the R-SLEEVE , then screw
back by two turns and a half.
Secure the ADJ, RING temporarily
with a screw.
Screw ACU3x3SA 1 Ρο. (31)
(2) Screw the COLUMNED PRISM ASS'Y
@ firmly in the R-SLEEVE (1).
1-3 Assemble the SHAFT ASS'Y.
(1)
Apply
a
small
amount
of
the
grease
to
the
parts
indicated
by
the
arrows,
then
assemble
them
in
order.
Grease OT1595
* When attaching the SHAFT © to
the BIC UNIT, it should be in-
stalled with the D-cut part (xX)
facing up.
Insert one screw each into the
R-PRISM MOUNT @)and the L-PRISM
MOUNT G).
Screw 3PUTS2x3SB 2 pcs. (*l)