12
PREPARA–
TIONS
LOADING THE BATTERIES
1
Check that the lens barrier is closed and both the
monitor and the green lamp are off.
2
Push the battery compartment
cover toward A and pull up in
the direction of B.
3
Insert the batteries as shown,
making sure that they are
correctly oriented.
4
Pull down the battery
compartment cover in the
direction of C and close
firmly by pressing the
mark in the direction
of D.
Note
• If the battery compartment cover is difficult to close, press on
the
mark and [OPEN] mark on the cover with your both
thumbs without applying unreasonable force.
• If the camera is left without batteries for about one hour, all
the settings will be reset to the default settings.
• When powering the camera by batteries, if the batteries start
to run low, the red battery status will be displayed. When the
batteries are close to exhaustion, the LCD monitor turns off
and the green lamp blinks.
A
B
D
C
To Next Page
Loading...
