24
TAKING
PICTURES
TAKING PICTURES
TAKING PICTURES USING THE MONITOR
1
Open the lens barrier.
2
Press the button.
The monitor will turn on.
Press the
button again to turn the
monitor off.
3
Compose the picture by looking
at the subject in the monitor.
4
Take the picture in the same
way as you would when using
the viewfinder.
See “Taking pictures using the viewfinder” ( p. 23).
Note
• If the green lamp blinks when the Shutter button is pressed
halfway, the flash is not fully charged. The green lamp blinks
while the camera is recording the picture taken. Wait for 2 to
40 seconds until the green lamp stops blinking.
• When the memory gauge is full, no more images can be
taken. Wait a few seconds until the memory gauge goes off
before taking any more pictures.
•
When a picture is taken in bright light, such as sunlight, vertical
lines may appear on the monitor. This is not a malfunction.
• The monitor is for checking the composition only. Check the
hand jitter, focus and exposure accuracy afterwards by
displaying the image on a PC.
• It will take longer to record a picture when the monitor is used.
To Next Page
Loading...
