73
TROUBLE–
SHOOTING
No picture is taken when the Shutter button is pressed
Cause Remedy Ref. Page
Power is off
Flash has not finished
charging, or previous
picture is being processed
Internal memory capacity
or card capacity is full
Batteries run out during
recording or while writing
data on card
Write-protected seal on
card
Images cannot be displayed on the monitor
Cause Remedy Ref. Page
Power is off
No images recorded on
internal memory or card
Cannot protect image, erase single or all images, or format card
Cause Remedy Ref. Page
Write-protect seal is affixed
to card
PROBLEMS
Open the lens barrier.
Release Shutter button and wait
until green lamp stops blinking.
Erase unwanted images, transfer
the images to a PC, or insert a
new card.
Change the batteries. (If green
lamp is blinking, wait until
recording is finished.)
Insert new card or remove the
seal.
P.18
P.26
P.16, 50
P.12
P.17
Close the lens barrier, press the
monitor button and turn the
monitor on.
Record images and then
playback.
P.18
P.23
Remove seal before using card.
Do not use the seal again.
P.17