TAKING STILL PICTURES
You can take stitl pictures using either the viewfinder or the monitor Both
methods are easy as all you have to do is to press the shutter button
Taking still pictures using the viewfinder
1 Set the mode dial to p A S M _ [] _, t_'_ _ and
turn the camera on.
2 Position the AF target mark in the viewfinder on the
subject.
3 Press the shutter button gently (halfway) to adjust the
focus.
• When the focus and exposureare locked, the green lamp lights.
• If the orange lamp lights, the flash fires automatically
4 Press the shutter button all the way (fully).
• The camera takes the picture
• The card access lamp blinkswhite the picture is stored on the card.
• When the green lamp stops blinking, you can take the next picture
Taking still pictures using the monitor
1 Set the mode dial to p A S M _ [] _, f_ _ _ and
turn the camera on.
2 Press G to turn the monitor on,
• You can aIso change the angle of the monitor when taking pictures
3 Position the AF target mark on the subject while looking at
the image on the monitor. Decide the composition of the
picture.
4 Take the picture by following the same procedure as for
shooting using the viewfinder.
• When the focus is locked by pressing tile shutter button halfway_ the
green lamp on the monitor lights. The AF target mark moves to the
focused position
32 En
To Next Page
Loading...
