Olympus CLV-180 - Page 55

Disassembly and Reassembly ProcedureCLV-180
4-18
ISSUE1
(3) Take off 8 SCREWS (CCUK3x6SZ:6, CBK2.5x6SA:2)
and MAIN BOARD

Phillips bit (№1)
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
HCBK3x6SA (4) Take off 7 SCREWS (HCBK3x6SA) and REAR
PANEL U
Phillips bit (№1)
Torque driver
Tightening torque 0.33 Nm
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(5) Take off CORE
*Pull CONNECTOR by pushing upper side
Phillips bit (№1)
Torque driver
Tightening torque 0.33 Nm
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm