Olympus CLV-180 - Page 54

Disassembly and Reassembly ProcedureCLV-180
4-17
ISSUE1
3-2-5 Igniter U
(1) Take off 1 NUT (6N
1
5BN) and take off components as
follows :
1 WASHER
- IGNITER HARNESS *terminal hole M3
BOX bit（size 8 mm）
Torque driver
Tightening torque 2.0 Nm
(2) Take off 1 NUT (6N
1
5BN) and take off HARNESS as
follows:
W03O008A (Red)
 1 WASHER
CONDENSER HARNESS
+ IGNITER HARNESS *terminal hole M4
BOX bit (size 8 mm）
Torque driver
Tightening torque 2.0 Nm
(3) Take off 1 NUT (6N
1
5BN) and take off HARNESS as
follows:
Take off IGNITER
W03O009A (Black)
 1 WASHER
CONDENSER HARNESS
BOX bit（size 8 mm）
Torque driver
Tightening torque 2.0 Nm
3-3 Area B
(1) Cut the BINDER and take off HARNESS from
BINDER
Nipper
(2) Take off each HARNESS connected to MAIN BOARD
(1) (2)
(3)
Tightened with STUD
on BASE