Olympus CLV-180 - Page 53

Disassembly and Reassembly ProcedureCLV-180
4-16
ISSUE1
(4) Take off 1 SCREW (CCUK3x6SZ) and take POLE F
and POLE SPACER off together.
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(5) First take off 1 SCREW (CCUK3x4SZ), and adjust
HARNESS、and then take off POLE R
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(6) Take off 2 SCREWS (CCUK3x4SZ) and SINK
RETAINER SPRING
Phillips bit (№2)
Torque driver
Tightening torque 0.6Nm
(7) Take off 1 SCREW (CCUK3x6SZ) , HARNESS and
DISCHARGE SPRING
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(8) Take off 1 SCREW (CCUK3x6SZ)、HARNESS and
DISCHARGE PLATE
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(9) Take off ER2.5SN, DISCHARGE BASE U and
DISCHARGE COIL
Long-nose Pliers
(10) Take off 1 SCREW (CCUK2x4SZ), DISCHARGE
SPINDLE
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(4)
(5) (6)
(8)
CCUK3x6SZ
HARNESS
DISCHARGE
SPRING
(10) ER2.5SN
(9)
CCUK3x6SZ
(11)
CCUK2x4SZ
DISCHARGE
PLATE
DISCHARGE COIL
DISCHARGE
COIL
POLE SPACER