Disassembly and Reassembly ProcedureCLV-180
4-15
ISSUE1
3-2-4 Shield case 260 eco U
(1) Take off GASKET 2
(2) Take off CABLE HOLDER
(3) Take off MINI CLAMP
(4) Take off CAUTION PLATE
(5) Take off 4 SCREWS(CCUK3x6SZ), HS GUIDE
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(6) Take off SHIELD MYLAR 1
(7) Take off SHIELD MYLAR 2
3-2-4 Lamp base U
(1) Take off 2 SCREWS(CCUK3x6SZ) and take off SINK
SPRING from POLE F
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(2) Take off 2 SCREWS(CCUK3x6SZ) and take off SINK
SPRING from POLE R
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(3) Take off 3 SCREWS (CCUK3x6SZ)
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
CABLE HOLDER
GASKET 2
CAUTION PLATE
MINI
CLAMP
SHIELD MYLAR 1
SHIELD MYLAR 2 CCUK3x6SZ
(3)
(1)
(2)
To Next Page
Loading...
