Olympus CLV-180 - Page 51

Disassembly and Reassembly ProcedureCLV-180
4-14
ISSUE1
3-2-3 Rear panel
(1) Take off NUT, WASHER and FOOT SW CONNECTOR
Open head (size 14 mm)
Torque driver
Tightening torque 1.2 Nm
(2) Take off 1 NUT(C6N3SZ) and GROUND CODE, and 1
WASHER
BOX bit (size 5.5 mm)
Torque driver
Tightening torque 0.6 Nm
(3) Take off 2 SCREWS (CCUK2.5x6SZ), EndoAlpha
CONNECTOR and RETAINING BASE
Phillips bit (№2)
Torque driver
Tightening torque 0.4 Nm
(4) Take off 4 SCREWS(CBK3x4SA) and REAR FOOT
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(5) Take off 2 NUTS(6N6SN), 1 WASHER and TERMINAL
Open head（size 10 mm）
Torque wrench
Tightening torque 5 Nm
(1)
FOOT SW
CONNECTOR
(2)
EndoAlpha
CONNECTOR
(3)
CCUK2.5x6SZ
RETAINING
BASE
REAR
FOOT
(4)
(5)
6N6SN
TERMINAL