Olympus CLV-180 - Page 57

Disassembly and Reassembly ProcedureCLV-180
4-20
ISSUE1
(2) Take off SCREW (CCUK3x6SZ)
(tightened with GROUND STRAP)
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(3) Take off 2 SCREWS (CCUK3x4SZ) and FRONT
PANEL
→Go to 3-4-1
Phillips bit (№2)
Torque driver
Tightening torque 0.6 Nm
(4) Cut 4 BINDERS (left figure) and take off TUBE from
VALVE U
Nipper
VALVE U
FRONT PANEL