19
Specifications
Table 1 Certified Cord
Voltage Rating
Current Rating
Temperature Rating
Length
Fittings Configuration
If no power supply cord is provided, please select the proper power supply cord for the equipment by referring to “Specifications"
and "Certified Cord" below.
CAUTION : In case you use a non-approved power supply cord for Olympus products, Olympus can no longer warrant
the electrical safety of the equipment.
PROPER SELECTION OF THE POWER SUPPLY CORD
125V AC (for 100-120V AC area) or, 250V AC (for 220-240V AC area)
6A minimum
60 minimum
3.05 m maximum
Grounding type attachment pulg cap Opposite teminates in molded-on IEC con-
figuration appliance coupling.
A power supply cord should be certified by one of the agencies listed in Table 1, or comprised of cordage marked with an
agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least one of agencies listed in Table 1.
In case you are unable to buy locally in your country the power supply cord which is approved by one of the agencies
mentioned in Table 1, please use replacements apprpved by any othere quivalent and authorized agencies in your country.
Country Agency Certification Mark Country Agency Certification Mark
Australia SAA
Austria ÖVE
Netherlands
KEMA
Belgium CEBEC Norway NEMKO
Canada CSA
Spain AEE
Denmark DEMKO Sweden SEMKO
Finland FEI
Switzerland SEV
France UTE United Kingdom ASTA, BSI
Germany VDE
U.S.A. UL
Ireland NSAI
Japan
JET, JQA, TÜV,
UL-APEX / MITI
Italy IMQ
Argentina IRAM
To Next Page
Loading...
