CX31
2
A warning label is affixed at parts where special precaution is required when handling and using the microscope. Always
heed the warnings.
Fig. 2
Indicates that the surface becomes hot, and should not be touched with bare hands.
Before use, carefully read the instruction manual. Improper handling could result in personal
injury to the user and/or damage to the equipment.
Indicates that the main switch is ON.
Indicates that the main switch is OFF.
ExplanationSymbol
1. A microscope is a precision instrument. Handle it with care and avoid
subjecting it to sudden or severe impact.
2. Do not use the microscope where it is subjected to direct sunlight,
high temperature and humidity, dust or vibrations. (For the operating
environment conditions, refer to and adhere to the conditions specified
in Chapter 6, “SPECIFICATIONS” on page 17.)
3. The tension of the coarse focus adjustment knob should only be
adjusted by means of the tension adjustment ring.
4. Heat from the microscope is led away by natural convection.
Consequently, leave an enough space (10 cm or more) on the rear of
the microscope and ensure that the room is well ventilated.
5. When moving the microscope, carefully carry it with one hand under
the base @ and the other hand holding at the recessed handle on the
rear of the arm ² as shown in the illustration on the left.
#Damage to the microscope will occur if you hold it by the stage, X-
axis/Y-axis knob, binocular section of the observation tube, etc.
Also be sure to remove the specimen to prevent it from falling off.
#Sliding the microscope on the surface of the table may damage or
tear off the rubber feet and/or scratch the table top surface.
Getting Ready
1
Safety Symbols
Warning Label
The following symbols are found on the microscope. Study the meaning of the symbols and always use the equipment in
the safest possible manner.
If the warning label becomes soiled, peeled off, etc., contact Olympus to have it replaced.
Base underside
(Caution for bulb replacement)
Warning label
position:
To Next Page
Loading...
Need help?
General
