CX41
24
Cables and cords are vulnerable when bent or twisted. Never
subject them to excessive force.
Make sure that the main switch is set to “ ” (OFF) before
connecting the power cord.
Always use the power cord provided by Olympus. IF no power
cord is provided with the microscope, please select the proper
power cord by referring to section “PROPER SELECTION OF THE
POWER SUPPLY CORD” at the end of this instruction manual.
1. Connect the power cord plug ² to the AC receptacle ³. (Fig. 31)
Connect the power cord to a grounded, 3-conductor power outlet
and ensure that the ground terminal of the power supply and that
of the wall outlet are properly connected.. If the equipment is not
grounded, Olympus can no longer warrant the electrical safety
performance of the equipment.
2. Plug the power cord plug | into the wall outlet ƒ. (Fig. 32)
Fig. 31
Connecting the Power Cord (Figs. 31 & 32)
8
Fig. 32
To Next Page
Loading...
