II'
='
0:1
=
-
:1:1
CD
...
0:1
~
..
is'
ID
24
listening
While
Audio
is
Recorded
If you start recording after inserting the earphone
into the EAR jack on the recorder, you can hear
the sound being recorded. The recording monitor
volume can be adjusted by using the VOLUME
dial.
Connect the earphone to the EAR jack
on
the recorder.
I
To
EAR
jack I
After recording has started, you can hear
the
sound
being
recorded
through
the
earphone. If the earphone
is
connected,
no sound will come from the ·speaker.
Recording level cannot
be
controlled using the
volume button.
When using the earphones, do NOT set the
volume too high. Listening at very high volume
may lead to hearing loss.
Do not place earphones near a microphone as
this may cause feedback.
When the external speaker
is
connected while
recording, there
is
a risk that audio feedback
will occur. It
is
recommended that you use
earphones for the recording monitor,
or
turn
[Ree Monitor] to
[Off]
while recording
(oF
P.34,
P.37).
When [Ree Monitor]
is
set to [Off] no sound
will come out of the earphones while you are
recording
(oF
P.34, P.37).
n
Set
the
low
Cut
Filter
The recorder has a Low Cut Filter function to
minimize
low-frequency
sounds
and
record
voices more clearly. This function
can
reduce
noise from air conditioners, projectors and other
similar noises.
Slide the LOW CUT ON/OFF switch and
select [ON] or [OFF].
...
lIJ(
I:
,...
~-
0
0
·
~O(J
·
·
\:1
\\
\'
'"
"
[ON]:
Enables the Low Cut Filter function.
[OFF]:
Disables this function.
Microphone
Sensitivity
Microphone
sensitivity
is
adjustable
to
meet
recording needs.
Slide the MIC SENSE HIGH/LOW switch
and select [HIGH] or [LOW].
o
To Next Page
Loading...
