Troubleshooting
Symptom
Probable
cause
Action
The batteries are not loaded properly.
Verify that the batteries' polarities
(!)
and
e are correct
(oT
P.9).
Nothing
appears
on
the
Battery power is getting low. Replace with new batteries (
...
P.9).
display
The power is off.
Turn the power on (
...
P.11).
Battery power is getting low.
Replace with new batteries (
...
P.9).
Won't start The power is off.
Turn the power on (
...
P.11).
The recorder is
in
HOLD mode. Release the recorder from HOLD (
...
P.11).
Low
remaining
memory.
Erase unnecessary files
('"
P.32).
Unable to record
The
maximum
number
of
files
has
Change to the another folder
been reached.
(
....
P.16
to
P.18,
P.20).
The
SO
Card is set
to
write protection.
Undo the
SO
Card's write protection setting
and then try again (
...
P.15).
No sound picked up by the
An
external
microphone
or
external
Detach
all
external microphones and
external devices connected
to
the LINE
IN
built-in microphone device
is
connected.
jack and the MIC jack (
....
P.25, P.26).
An
external device
is
connected
to
the
Detach the connecting cord from the
LINE IN jack. recorder.
Unable
to record through
An
external microphone supported
by
Set
[Plug·inPower]
to [On) when
an
an
external microphone
plug·in power is connected but [Plug.in external microphone supported
by
plug-in
Power) is set to
[Off].
power is connected (
...
P.34, P.37).
The
earphone
is
connected.
Unplug the earphones to use the internal
speaker.
No
playback tone heard
The volume level
is
set to [0].
Adjust the volume level (... P.27).
The recording level has not been
ad·
Adjust the recording level and then try
justed.
recording once more (
...
P.20).
The microphone sensitivity
is
too
low.
Set the microphone sensitivity to [HIGH)
Recording level too
low
mode and try again (
..
, P.24).
This could potentially be because the
If you cannot record clearly even after
recording level and output level for the
adjusting the recording level, then adjust the
output level for the connected devices
connected external devices are too low.
(oT
P20).
The recording level has not been ad- Adjust the recording level and then try
justed.
recording once more
(,
..
P.20).
Recording level too high
This could potentially be because the
If you cannot record clearly even after
recording level and output level for con-
adjusting the recording level, then adjust the
output level for the connected devices
nected external devices are too high.
(
....
P.20).
II
63
To Next Page
Loading...
